Brocade Network OS Command Reference v4.1.0 - Manual (Page 1356)

1318 Network OS Command Reference
53-1003115-01
threshold-monitor sfp
2
threshold-monitor sfp
Configures monitoring of SFP parameters.
Synopsis threshold-monitor sfp {[apply policy_name | pause | policy policy_name] type SFP_type area
parameters
alert
[above [highthresh-action [[all | lowthresh-action] | email | none | raslog] |
lowthresh-action [all | email none | raslog] |
below [highthresh-action [all | email | none raslog] | lowthresh-action [all | email |
none | raslog]] |
threshold
[buffer | high-threshold | low-threshold | timebase [day | hour | minute | none]]]}
no threshold-monitor sfp
Operands apply Applies a custom policy that has been created by the policy operand.
policy_name Name of a custom policy configuration created by the policy operand.
pause Pause monitoring.
policy Specifies a policy name for monitoring by means of custom settings, rather
than default settings. A policy name is required before additional
configurations can be made. This operation is not supported from a
secondary node.
policy_name Name of a custom policy configuration that can be saved and applied by
means of the apply operand.
type Specifies the SFP type. Possible completions are as follows:
1GLR — SFP Type 1GLR
1GSR — SFP Type 1GSR
10GLR — SFP Type 10GLR
10GSR — SFP Type 10GSR
10GUSR — SFP Type 10GUSR
100GSR —SFP Type 100GSR
QSFP — SFP type QSFP
area Specifies one of the following SFP parameters to be monitored. See
Defaults, below.
Current Measures the current supplied to the SFP transceiver.
RXP Measures the incoming laser power, in microWatts ( µW) .
TXP Measures the outgoing laser power, in µW) .
Temperature Measures the temperature of the SFP, in degrees Celsius.
Voltage Measures the voltage supplied to the SFP.
alert Specifies whether an alert is sent when a threshold value is either above or
below a threshold trigger.