Brocade Network OS Command Reference v4.1.0 - Manual (Page 561)

Network OS Command Reference 523
53-1003115-01
nport interface Fibrechannel
2
nport interface Fibrechannel
Adds or deletes N_Ports in a specified port group for Access Gateway mode.
Synopsis nport interface Fibrechannel port
no nport interface Fibrechannel port
Operands port N_Port number supported by switch model.
Defaults None
Command Modes Port Grouping configuration mode
Description Adds or deletes N_Ports in a port group.
Usage Guidelines To use this command, you must be in Port Grouping configuration mode for a specific port group.
Before adding an N_Port to a port group, you must remove the N_Port from its current port group
unless the port resides in default port group 0 (pg 0). N_Ports are identified by the format
rbridge-id/slot/N_Port, such as 3/0/4 for RBridge 3, slot 0, and N_Port 4.
Examples Adding N_Port 3/0/3 to port group 2 (pg 2):
sw0(config-rbridge-id-3-ag-pg-2)# nport interface Fibrechannel 3/0/3
Removing N_Port 3/0/3 from port group 3 (pg 3)
sw0(config-rbridge-id-3-ag-pg-3)# nport interface Fibrechannel 3/0/3
See Also pg, show ag pg