Brocade Network OS Command Reference v4.1.0 - Manual (Page 613)

Network OS Command Reference 575
53-1003115-01
qos dscp-cos
2
qos dscp-cos
Applies a defined DSCP-CoS map to an interface,
Synopsis qos dscp-cos name
no qos dscp-cos
Operands name Name of DSCP-to-COS mutation map
Defaults DSCP-to-CoS mutation is not enabled on interface.
Command Modes Interface subconfiguration mode (fo, gi, port-channel, te)
Description Use this command to apply a DSCP-to-COS mutation map defined by the qos map dscp-cos name
command to a specific interface.
Usage Guidelines Enter no qos dscp-cos while in the interface mode to remove the DSCP-CoS map from the
interface.
Examples To apply a configured QoS dscp-mutation map named test to a specific interface, enter the
qos dscp-cos name command while in the interface subconfiguration mode:
switch(config)# interface tengigabitethernet 16/2/2
switch(conf-if-te-16/2/2)# qos dscp-cos test
To remove a configured QoS dscp-mutation map named test from a specific interface, enter the
no qos dscp-cos command while in the interface subconfiguration mode:
switch(config)# interface tengigabitethernet 16/2/2
switch(conf-if-te-16/2/2)# no qos dscp-cos
See Also interface, qos dscp-mutation, qos map dscp-cos, show qos maps dscp-cos, qos dscp-cos,
show qos maps dscp-cos