Brocade Network OS Command Reference v4.1.0 - Manual (Page 829)

Network OS Command Reference 791
53-1003115-01
show fcoe fabric-map
2
show fcoe fabric-map
Displays the FCoE fabric-map configuration globally in a fabric, or on a single RBridge.
Synopsis show fcoe fabric-map [rbridge-id rbridge-id]
Operands rbridge-id rbridge-id Optionally selects the fabric-map configuration on a single RBridge ID.
Defaults None
Command Modes Privileged EXEC mode
Description Use this command to display the FCoE fabric-map on all or one of the RBridges in a fabric.
Usage Guidelines None
Examples To display the fabric-map configuration on all RBridges in the fabric:
switch# show fcoe-fabric-map
======================================================================================
Fabric-Map VLAN VFID Pri FCMAP FKA Timeout Total-FCoE-Enodes
======================================================================================
default 1002[D] 128[D] 3[D] 0xefc00[D] 8000[D] Enabled[D] 264
To display the fabric-map configuration for a single RBridge:
switch# show fcoe-fabric-map rbridge-id 19
======================================================================================
Fabric-Map VLAN VFID Pri FCMAP FKA Timeout FCoE-Enodes
======================================================================================
default 1002[D] 128[D] 3[D] 0xefc00[D] 8000[D] Enabled[D] 200
To display the fabric-map configuration where the number of FCoE ENodes is the default value:
switch# show fcoe-fabric-map rbridge-id 20
======================================================================================
Fabric-Map VLAN VFID Pri FCMAP FKA Timeout FCoE-Enodes
======================================================================================
default 1002[D] 128[D] 3[D] 0xefc00[D] 8000[D] Enabled[D] 64 [D]
To display the fabric-map configuration where no FCoE license is present:
switch# show fcoe-fabric-map rbridge-id 21
======================================================================================
Fabric-Map VLAN VFID Pri FCMAP FKA Timeout FCoE-Enodes
======================================================================================
default 1002[D] 128[D] 3[D] 0xefc00[D] 8000[D] Enabled[D] 0
The command show running-config rbridge-id rbridge-id also shows the status of “fabric-map” and
“fcoe-enode” under “fcoe,” as in the following example:
sw0# show running-config rbridge-id 19
rbridge-id 19
: