Brocade Network OS Command Reference v4.1.0 - Manual (Page 264)

226 Network OS Command Reference
53-1003115-01
diag setcycle
2
diag setcycle
Configures all the parameters required for the system verification test.
Synopsis diag setcycle
Operands None
Defaults Referto the Usage Guidelines.
Command Modes Privileged EXEC mode
Description Use this command to set the user-defined parameters for running a system verification test.
Usage Guidelines If, after you enter the diag setcycle command, you respond with yes, the following settings are the
default values:
• num_of_runs: 1. Valid values for number of runs are 1 through 25.
• min_lb_mode: 2. Valid values for minimum loopback mode are 1 (external) or 2 (internal).
If set to 1, all the external user ports must be connected with small form-factor pluggable
devices (SFPs) and loopback plugs.
• pled_passes: 1. Valid values for the number of portLedTest loops are 1 through 10.
• tbr_passes: 1. Valid values for the number of turboRamTest loops are 1 through 10.
This parameter is not supported on fixed configuration switches.
• plb_nframes:16. Valid values for the number of portLoopbackTests are 4 through 16.
If you respond with no, the system prompts you for these values.
Examples To change the value of num_of_runs parameter to 3:
switch# diag setcycle num_of_runs 3
Setting number_of_runs to 3.
Committing changes to configuration
In slot-based switches:
0 is not a valid number of passes. See sample below.
rontee128# diag setcycle num_of_runs 0
-------------------------------------^
syntax error: "0" is out of range.
switch# diag setcycle
Do you want use default values [Y/N]? : y
DEFAULT - KEYWORD : COMMENT
replacing 2 with default 1
1 - number_of_runs : number of passes of verify
2 - min_lb_mode : Limits -lb_mode of tests
VERIFY - label : Label for run start and stop messages
1 - tbr_passes : turboramtest number of passes
replacing 8 with default 16
16 - plb_nframes : portloopbacktest number of frames default speed
1 - pled_passes : portledtest number of passes
1 - prbs_p7 : LC Backplane test with pattern PRBS7+
16 - cplb_nframes : portloopbacktest in Core Blade number of frames
Committing changes to configuration
switch# diag setcycle
Do you want use default values [Y/N]? : y