Brocade Network OS Command Reference v4.1.0 - Manual (Page 793)

Network OS Command Reference 755
53-1003115-01
show environment temp
2
show environment temp
Displays environment temperature.
Synopsis show environment temp [rbridge-id {rbridge-id | all}]
Operands rbridge-id Executes the command on the specified switches. Valid completions for
rbridge-id include the following:
rbridge-id Specifies the RBridge ID. This parameter is not valid in standalone mode,
and is supported only for the local RBridge ID.
all Specifies all switches in the fabric. This parameter is not supported.
Defaults None
Command Modes Privileged EXEC mode
Description Use this command to display the current temperature readings of all temperature sensors in a
switch. For each sensor, Use this command to display the sensor ID, the slot number (on modular
chassis only), the sensor state, and the temperature. The temperature readings are given in both
Centigrade and Fahrenheit.
Usage Guidelines This command is supported only on the local switch.
Refer to the hardware reference manual for your switch to determine the normal temperature
range.
Examples To display the temperature readings on a Brocade VDX 6720-24:
switch# show environment temp
Sensor State Centigrade Fahrenheit
ID
=================================================
1 Ok 36 96
2 Ok 40 104
3 Ok 32 89
See Also show environment fan, show environment history, show environment power,
show environment sensor