Brocade Network OS Command Reference v4.1.0 - Manual (Page 554)

516 Network OS Command Reference
53-1003115-01
neighbor update-source (BGP)
2
neighbor update-source (BGP)
Configures the device to communicate with a neighbor through a specified interface.
Synopsis neighbor {ip-address | peer-group-name} update-source ip-addr | {tengigabitethernet |
gigabitethernet | fortygigabitethernet} rbridge-id/slot/portnum | loopback num | ve-interface
vlan_id]
no neighbor {ip-address | peer-group-name} update-source ip-addr | {tengigabitethernet |
gigabitethernet | fortygigabitethernet} rbridge-id/slot/portnum | loopback num | ve-interface
vlan_id]
Operands ip-address IPv4 address of the neighbor
peer-group-name Peer group name configured by the neighbor peer-group-name command.
ip-addr IP address of the update source.
tengigabitethernet 10-gigabit Ethernet interface
gigabitethernet 1-gigabit Ethernet interface
fortygigabitethernet 40-gigabit Ethernet interface.
rbridge-id Routing bridge ID
slot Slot number
portnum Port number
loopback num Specifies a loopback interface.
ve-interface vlan_id Specifies a virtual Ethernet VLAN interface. Refer to the Usage Guidelines.
Defaults None
Command Modes BGP configuration mode
Description Use this command to configure the device to communicate with a neighbor through a specified
interface.
Usage Guidelines Use the no form of the command to restore the defaults.
On the Brocade VDX family of hardware, VLANs are treated as interfaces from a configuration
point of view. By default all the DCB ports are assigned to VLAN 1 (VLAN ID equals 1).
Valid VLAN IDs are as follows:
• On Brocade VDX 8770 switches: 1 through 4086 for 802.1Q VLANs (VLAN IDs 4087
through 4095 are reserved on these switches), and 4096 through 8191 for service or
transport VFs in a Virtual Fabrics context.
• On all other Brocade VDX switches: 1 through 3962 for 802.1Q VLANs (VLAN IDs 3963
through 4095 are reserved on these switches), and 4096 through 8191 for service or
transport VFs in a Virtual Fabrics context.
Examples Typical command example.
switch(config)# rbridge-id 10
switch(config-rbridge-id-10)# router bgp
switch(config-bgp-router)# neighbor 10.11.12.13 update-source
10.11.12.14tengigabitethernet 15/1/1