Brocade Network OS Command Reference v4.1.0 - Manual (Page 424)

386 Network OS Command Reference
53-1003115-01
ip ospf retransmit-interval
2
ip ospf retransmit-interval
Configures retransmit interval.
Synopsis ip ospf retransmit-interval rtx-int
no ip ospf retransmit-interval
Operands rtx-int Retransmit interval in seconds. Valid values range from 0 through
3600 seconds.
Defaults 5 seconds.
Command Modes Interface subtype configuration mode
Description Use this command to set the time between Link-State Advertisement (LSA) retransmissions to
adjacent routers for this interface.
Usage Guidelines Enter no ip ospf retransmit-interval to reset the retransmit interval to its default.
Examples To set the retransmit interval to 10 for all OSPF routers on the OS-gigabit Ethernet interface
190/0/49:
switch(config)# interface tengigabitethernet 190/0/49
switch(conf-if-te-190/0/49)# ip ospf retransmit 10
To set the retransmit interval to 50 for all OSPF routers on the OSPF virtual Ethernet (VE)
interface 24:
switch(config)# rbridge-id 178
switch(config-rbridge-id-178)# interface ve 24
switch(config-ve-24)# ip ospf retransmit 50
See Also interface, interface ve, ip ospf area, ip ospf auth-change-wait-time, ip ospf authentication-key,
ip ospf cost, ip ospf database-filter, ip ospf dead-interval, ip ospf hello-interval,
ip ospf md5-authentication, ip ospf mtu-ignore, ip ospf network, ip ospf passive, ip ospf priority,
ip ospf transmit-delay