Brocade Network OS Command Reference v4.1.0 - Manual (Page 1029)

Network OS Command Reference 991
53-1003115-01
show route-map interface
2
show route-map interface
Displays the status of a route-map application on the specified interface.
Synopsis show route-map interface {port-channel index | gigabitethernet slot/port |tengigabitethernet
slot/port | fortygigabitethernet slot/port | ve vlan-id}
show route-map interface ve vlan-id rbridge-id {rbridge-id | all}
Operands port-channel index Displays the status of the port-channel interface.
gigabitethernet slot/port
Displays the configuration of all 1-gigabit Ethernet interfaces on the local
switch.
tengigabitethernet slot/port
Displays the configuration of all 10-gigabit Ethernet interfaces on the local
switch.
fortygigabitethernet slot/port
Displays the configuration of all 40-gigabit Ethernet interfaces on the local
switch.
ve vlan-id Displays the status of a route-map application on the specified virtual
Ethernet interface Ve for the mentioned rbridge-id.
rbridge-id Enables RBridge ID mode to support Virtual Cluster Switching (VCS) on
individual nodes.
rbridge-id Specifies a unique identifier for a node. Values can be a range of nodes or
individual nodes and are separated by a comma.
all Specifies all identifiers for a node. The command applies to all of the
nodes.
Defaults None
Command Modes Privileged EXEC mode
Description This command displays the status of a route-map application on the specified interface.
Usage Guidelines You do not need to specify the route map name, as only a single route map can be applied to an
interface.
Examples To display the status of a route map on a 10-gigabit Ethernet interface:
sw0# show route-map interface tengigabitethernet 3/3
Interface TenGigabitEthernet 3/3
ip policy route-map foo permit 10 (Active)
match ip address acl ACL_Vincent
set ip next-hop 3.3.1.1 (selected)
set ip next-hop 4.4.2.1
Policy routing matches: 100 packets; 500000 bytes
ip policy route-map foo permit 20 (Active)
match ip address acl ACL_Vincent_2
set ip next-hop 10.3.1.1
set ip next-hop 10.4.2.1 (selected)