Brocade Network OS Command Reference v4.1.0 - Manual (Page 1200)

1162 Network OS Command Reference
53-1003115-01
show slots
2
show slots
Displays information about the modules present in the chassis.
Synopsis show slots
Operands None
Defaults None
Command Modes Privileged EXEC mode
Description Use this command to display information about all modules present in a modular switch. The
output includes the following information:
Slot Displays the slot number. Slots for interface modules are L1 through L4 on
Brocade VDX 8770-4 switches, and L1 through L8 on the
Brocade VDX 8770-8 switches.
Type Displays the module type. Valid types include the following:
MM Management Module
SFM Switch Fabric Module
LC48X10G 48-port 10 GbE interface module (line card)
LC48X1G 48-port 1 GbE interface module
LC12X40G 12-port 10 GbE interface module
Description Module description
ID Module ID
112 Management Module
113 Switch Fabric Module
114 48-port 10GbE interface module
127 12-port 10 GbE interface module
Status Displays the status of the module as one of the following:
VACANT The slot is empty.
POWERED-OFF The module is present in the slot but is powered off.
POWERING UP The module is present and powering on.
LOADING The module is present, powered on, and loading the initial configuration.
DIAG RUNNING POST1
The module is present, powered on, and running the POST (power-on
self-test). This status is not valid for the management modules.
DIAG RUNNING POST2
The module is present, powered on, and running the reboot power on self
tests. This status is not valid for the management modules.
INITIALIZING The module is present, powered on, and initializing hardware components.
ENABLED The module is on and fully enabled.