Brocade Network OS Command Reference v4.1.0 - Manual (Page 299)

Network OS Command Reference 261
53-1003115-01
error-disable-timeout interval
2
error-disable-timeout interval
Sets the timeout for errors on an interface.
Synopsis error-disable-timeout interval seconds
no error-disable-timeout interval
Operands seconds Specifies the time for the interface to time out. Valid values range from 10
through 1000000 seconds.
Defaults 300 seconds
The timeout feature is disabled.
Command Modes Protocol Spanning Tree configuration mode
Description Use this command to set the interface to time out when an error occurs.
Usage Guidelines If xSTP is enabled over VCS, this command must be executed on all the RBridge nodes.
Enter no error-disable-timeout interval to return to the default setting.
Examples To set the timeout value to 10 seconds:
switch(conf-rstp)# error-disable-timeout interval 10
See Also error-disable-timeout enable