Brocade Network OS Command Reference v4.1.0 - Manual (Page 1331)

Network OS Command Reference 1293
53-1003115-01
switchport trunk tag native-vlan
2
switchport trunk tag native-vlan
Enables tagging on native VLAN traffic.
Synopsis switchport trunk tag native-vlan
no switchport trunk tag native
Operands None
Defaults None
Command Modes Interface subtype configuration mode
Description Use this command to enable tagging for native traffic on a specific interface.
Usage Guidelines Enter no switchport trunk tag native to untag native traffic for a specific interface.
Examples To enable tagging for native traffic on a specific 10-gigabit Ethernet interface:
switch(config)# interface tengigabitethernet 178/0/9
switch(conf-if-te-178/0/9)# switchport trunk tag native-vlan
See Also interface, show vlan, switchport mode, switchport trunk allowed vlan rspan-vlan,
switchport trunk native-vlan