Brocade Network OS Command Reference v4.1.0 - Manual (Page 1348)

1310 Network OS Command Reference
53-1003115-01
threshold-monitor cpu
2
threshold-monitor cpu
Configures monitoring of CPU usage of the system and alerts the user when configured thresholds
are exceeded.
Synopsis threshold-monitor cpu {[actions [none | raslog [{limit limit_when_reached | poll polling_interval |
retry number_of_retries]]}
no threshold-monitor cpu
Operands actions Specifies the action to be taken when a threshold is exceeded.
none No action is taken.
raslog Specifies RASLog messaging.
limit Specifies the baseline CPU usage limit as a percentage of available
resources.
limit_when_reached
When the limit set by this parameter is exceeded, a RASLog WARNING
message is sent. When the usage returns below the limit, a RASLog INFO
message is sent. Valid values range from 0 through 80 percent. The default
is 70 percent.
poll Specifies the polling interval in seconds.
polling_interval The range is from 0 through 3600. The default is 120
retry Specifies the number of polling retries before desired action is taken.
number_of_retries
Range is from 1 through 100. The default is 3.
Defaults Refer to the Operands for specific defaults.
Command Modes RBridge ID configuration mode
Description Use this command to monitor CPU usage and send a RASLog WARNING message when configured
thresholds are exceeded.
Usage Guidelines None
Examples
switch(config-rbridge-id-154)# threshold-monitor cpu actions rasloglimit 50
poll10
See Also rbridge-id