Brocade Network OS Command Reference v4.1.0 - Manual (Page 420)

382 Network OS Command Reference
53-1003115-01
ip ospf mtu-ignore
2
ip ospf mtu-ignore
Enables or disables MTU-match checking.
Synopsis ip ospf mtu-ignore
no ip ospf mtu-ignore
Operands None
Defaults Enabled
Command Modes Interface subtype configuration mode
Description Use this command to enable or disable MTU-match checking. In default operation, the IP MTU on
both sides of an OSPF link must be the same, and a check of the MTU is performed when Hello
packets are first exchanged.
Usage Guidelines Enter no ip ospf mtu-ignore to disable MTU-match checking on a specific interface.
Examples To disable MTU-match checking on a specific OSPF 40-gigabit Ethernet interface:
switch(config)# interface fortygigabitethernet 101/0/10
switch(conf-if-fo-101/0/10)# no ip ospf mtu-ignore
To disable MTU-match checking on a specific OSPF virtual Ethernet (VE) interface:
switch(config)# rbridge-id 178
switch(config-rbridge-id-178)# interface ve 24
switch(config-ve-24)# no ip ospf mtu-ignore
See Also interface, interface ve, ip ospf area, ip ospf auth-change-wait-time, ip ospf authentication-key,
ip ospf cost, ip ospf database-filter, ip ospf dead-interval, ip ospf hello-interval,
ip ospf md5-authentication, ip ospf network, ip ospf passive, ip ospf priority,
ip ospf retransmit-interval, ip ospf transmit-delay