Brocade Network OS Command Reference v4.1.0 - Manual (Page 720)

682 Network OS Command Reference
53-1003115-01
sfp breakout
2
sfp breakout
Displays the QSFP port breakout configurations.
Synopsis sfp breakout
no sfp breakout
Operands None
Defaults Breakout mode is set to disabled.
Command Modes Connector configuration mode
Description Use this command to display the QSFP port breakout configuration for the specified QSFP ports.
Usage Guidelines This command is an executable command and it could be executed under connector mode.
This command is destructible and irreversible. After this command, you must execute the “copy
running-config startup-config” command, and immediately perform a power-cycle on the
corresponding linecard/switch.
Use the no sfp breakout to disable breakout mode and create a single Fo interface.
Examples To enable SFP breakout on a connector:
switch(config)# hardware
switch(config-hardware)#connector 2/0/1
switch(config-connector-2/0/1)# sfp breakout
To disable SFP breakout on a connector:
switch(config-connector-2/0/1)# no sfp breakout
See Also show running-config hardware connector, connectorpower-off linecard, power-on linecard