Spanning-tree bpdu-mac – Brocade Network OS Command Reference v4.1.0 User Manual

Page 1275

Text mode
Original mode

Network OS Command Reference

1237

53-1003115-01

spanning-tree bpdu-mac

Sets the MAC address of the Bridge Protocol Data Unit (BPDU).

Synopsis

spanning-tree bpdu-mac [0100.0ccc.cccd | 0304.0800.0700]

no spanning-tree bpdu-mac [0100.0ccc.cccd | 0304.0800.0700]

Operands

0100.0ccc.cccd

Cisco Control Mac

0304.0800.0700

Brocade Control Mac

Defaults

None

Command Modes

Interface subtype configuration mode

Description

Use this command to explicitly set the MAC address of the BPDU. This command will only take
effect when the protocol is PVST+ or R-PVST+.

If xSTP is enabled over VCS, this command must be executed on all the RBridge nodes.Brocade
Network OS v4.1.0 supports PVST+ and R-PVST+only. The PVST and R-PVST protocols are
proprietary to Cisco and are not supported.

Usage Guidelines

Enter no spanning-tree bpdu-mac 0100.0ccc.cccd to remove the address.

Examples

None