Brocade Network OS Command Reference v4.1.0 - Manual (Page 1056)

1018 Network OS Command Reference
53-1003115-01
show running-config interface fortygigabitethernet dot1x
2
show running-config interface fortygigabitethernet dot1x
Displays IEEE 802.1x port-based access control configuration information for a 40-gigabit
Ethernet interface.
Synopsis show running-config interface fortygigabitethernet [rbridge-id/slot/port] dot1x [authentication |
port-control | protocol-version | quiet-period | reauthMax | reauthentication | timeout
[re-authperiod | server-timeout | supp-timeout | tx-period]]
Operands rbridge-id Specifies a switch by its RBridge ID.
slot Specifies a valid slot number.
port Specifies a valid port number.
authentication Indicates whether 802.1x port-based access control is enabled on the
interface.
port-control Displays the status of port authorization: auto (authentication on the port is
enabled), forced authorize, or force unauthorize.
protocol-version Displays the version number of the dot1x protocol.
quiet-period Displays the number of seconds between a failed authentication and the
next authentication retry.
reauthMax Displays the maximum number of reauthentication attempts before the
port goes into the reauthorized state.
reauthentication Indicates whether reauthentication is enabled on a port.
timeout Displays 802.1x timeout values.
re-authperiod Displays the reauthentication interval in seconds.
server-timeout Displays the number of seconds the switch waits for a response from the
authentication server.
supp-timeout Displays the number of seconds that the switch waits for a response to the
Extensible Authentication Protocol (EAP) frame.
tx-period Displays the number of seconds that the switch waits for a response to an
EAP request or identity frame from the client before retransmitting the
request
Defaults None
Command Modes Privileged EXEC mode
Description Use this command to display configuration information for an interface configured for IEEE 802.1x
port-based access control.
Usage Guidelines None
Examples To display the 802.1x port-based authentication configuration for a 40-gigabit Ethernet interface:
switch# show running-config interface fortygigabitethernet 1/0/49 dot1x
interface fortygigabitethernet 1/0/49
dot1x authentication
dot1x port-control auto
dot1x quiet-period 120