Brocade Network OS Command Reference v4.1.0 - Manual (Page 497)

Network OS Command Reference 459
53-1003115-01
match interface
2
match interface
Matches interface conditions in a route-map instance.
Synopsis match interface [fortygigabitethernet rbridge-id/slot/port | gigabitethernet rbridge-id/slot/port |
loopback | tengigabitethernet rbridge-id/slot/port | ve
rbridge-id/slot/port]
no match interface
Operands fortygigabitethernet Specifies a 40-GbE interface.
gigabitethernet Specifies a 1-GbE interface.
loopback Specifies a loopback port. Values range from 1 through 255.
tengigabitethernet Specifies a 10-GbE interface.
ve Specifies a virtual Ethernet port. Range is from 2 through 4090.
rbridge-id Specifies the RBridge ID.
slot Specifies the slot number.
port Specifies the port number.
Defaults None
Command Modes Route-map configuration mode
Description Use this command to configure the interface match clause in a route-map instance. A maximum of
three interfaces is supported.
Usage Guidelines None
Examples None
See Also route-map