Show mm – Brocade Network OS Command Reference v4.1.0 User Manual
Page 965
Network OS Command Reference
927
53-1003115-01
show mm
2
show mm
Displays information about the Management Modules present in the chassis.
Synopsis
show mm
Operands
None
Defaults
None
Command Modes
Privileged EXEC mode
Description
Use this command to display information about the management modules present in a modular
switch. The output includes the following information:
Slot
Displays the slot number. Slots for management modules are M1 and M2.
Type
Displays the interface module type. The management module type is MM.
Description
Module description
ID
Displays the module ID. The ID for the management module is 112.
Status
Displays the status of the module as one of the following:
VACANT
The slot is empty.
POWERED-OFF
The module is present in the slot but is powered off.
POWERING UP
The module is present and powering on.
LOADING
The module is present, powered on, and loading the initial configuration.
INITIALIZING
The module is present, powered on, and initializing hardware components.
ENABLED
The module is on and fully enabled.
DISABLED
The module is powered on but disabled.
FAULTY
The module is faulty because an error was detected.
UNKNOWN
The module is inserted but its state cannot be determined.
Usage Guidelines
Diagnostic tests (POST1, POST2) are not running on the management modules.
Examples
To display the management modules present in a Brocade VDX 8770-4 chassis:
switch# show mm
Slot
Type
Description
ID
Status
----------------------------------------------------------------------
M1
MM
Management Module
112
ENABLED
M2
VACANT
See Also