Brocade Network OS Command Reference v4.1.0 - Manual (Page 558)

520 Network OS Command Reference
53-1003115-01
next-hop-enable-default (BGP)
2
next-hop-enable-default (BGP)
Configures the device to use the default route as the next hop.
Synopsis next-hop-enable-default
no next-hop-enable-default
Operands None
Defaults None
Command Modes BGP address-family IPv4 unicast configuration mode
Description Use this command to configure the device to use the default route as the next hop.
Usage Guidelines Use the no form of this command to restore the default.
Examples
switch(config)# rbridge-id 10
switch(config-rbridge-id-10)# router bgp
switch(config-bgp-router)# address-family ipv4 unicast
switch(config-bgp-ipv4u)# next-hop-enable-default
See Also None