Brocade Network OS Command Reference v4.1.0 - Manual (Page 192)

154 Network OS Command Reference
53-1003115-01
conform-set-dscp
2
conform-set-dscp
Optional command for configuring the packet DSCP priority of a class-map.
Synopsis conform-set-dscp dscp-num
no conform-set-dscp dscp-num
Operands dscp-num Specifies that traffic with bandwidth requirements within the rate
configured for CIR that has the packet DSCP priority set to the value
specified by the dscp-num variable. Valid values are 0 through 63.
Defaults None
Command Modes Policy-map class police configuration mode
Description This command configures the packet DSCP priority of a class-map.
Usage Guidelines Only the police cir and cbs commands are mandatory for configuring a class-map.
If the optional parameters for a class-map are not set, they are treated as disabled. To delete
parameters for a class-map, you must delete all policer parameters while in the policy-map class
configuration mode using the no police cir command.
This command is only supported on Brocade VDX 8770-4, VDX 8770-8, and later switches.
Use the no version of this command to remove the parameter from the class-map.
Examples Example of setting this parameter.
switch(config-policymap)# class default
switch (config-policymap-class)# police cir 40000
switch(config-policymap-class-police)# conform-set-dscp 3
See Also cbs, conform-set-prec, conform-set-tc, ebs, eir, exceed-set-dscp, exceed-set-prec, exceed-set-tc,
police cir, police-priority-map, policy-map, qos cos, service-policy, set-priority