Brocade Network OS Command Reference v4.1.0 - Manual (Page 194)

156 Network OS Command Reference
53-1003115-01
conform-set-tc
2
conform-set-tc
Optional command for configuring the CIR internal queue assignment of a class-map.
Synopsis conform-set-tc trafficclass
no conform-set-tc trafficclass
Operands trafficclass Specifies that traffic with bandwidth requirements within the rate
configured for CIR will have traffic class (internal queue assignment) set to
the value in the trafficclass variable. Valid values are 0 through 7.
Defaults None
Command Modes Policy-map class police configuration mode
Description This command configures the CIR internal queue assignment of a class-map.
Usage Guidelines Only the police cir and cbs commands are mandatory for configuring a class-map.
If the optional parameters for a class-map are not set, they are treated as disabled. To delete
parameters for a class-map, you must delete all policer parameters while in the policy-map class
configuration mode using the no police cir command.
This command is only supported on Brocade VDX 8770-4, VDX 8770-8, and later switches.
Use the no version of this command to remove the parameter from the class-map.
Examples Example of setting this parameter.
switch(config-policymap)# class default
switch (config-policymap-class)# police cir 40000
switch(config-policymap-class-police)# conform-set-tc 3
See Also cbs,conform-set-dscp, conform-set-prec, ebs, eir, exceed-set-dscp, exceed-set-prec, exceed-set-tc,
police cir, police-priority-map, policy-map, qos cos, service-policy, set-priority