Brocade Network OS Command Reference v4.1.0 - Manual (Page 491)

Network OS Command Reference 453
53-1003115-01
match
2
match
Creates a classification map or “class-map” to classify traffic based on configured match criteria.
Synopsis match criteria
Operands criteria Used while in config-classmap mode to configure the match criteria for the
class.
Defaults The only available match criteria at this time is “match any.”
Command Modes Class-map configuration mode
Description Use this command to classify traffic based on match criteria. When you launch the class-map
command, the system is placed in config-classmap mode for the configured map. At this point, you
can provide match criteria for the class. The only available match criteria at this time is
“match any.”
Usage Guidelines This command is only supported on Brocade VDX 8770-4, VDX 8770-8, and later switches.
Examples To configure “match any” match criteria for the class while in config-classmap mode:
switch(config-classmap)# match any
See Also show running-config class-map, class-map