Brocade Network OS Command Reference v4.1.0 - Manual (Page 1286)

1248 Network OS Command Reference
53-1003115-01
spanning-tree restricted-tcn
2
spanning-tree restricted-tcn
Restricts the topology change notification Bridge Protocol Data Units (BPDUs) sent on the port.
Synopsis spanning-tree restricted-tcn
no spanning-tree restricted-tcn
Operands None
Defaults The restricted TCN is disabled.
Command Modes Interface subtype configuration mode
Description Use this command to restrict the topology change notification BPDUs sent on the port.
Usage Guidelines Enter no spanning-tree restricted-tcn to disable this parameter.
If xSTP is enabled over VCS, this command must be executed on all the RBridges.
Examples To restrict the TCN on a specific interface:
switch(config)# interface tengigabitethernet 0/1
switch(conf-if-te-0/1)# spanning-tree restricted-tcn
See Also show spanning-tree