Map fport interface fcoe – Brocade Network OS Command Reference v4.1.0 User Manual

Page 488

450

Network OS Command Reference

53-1003115-01

map fport interface fcoe

Maps VF_Ports to N_Ports in Access Gateway (AG) mode and removes VF_Port to N_Port mapping.

Synopsis

map fport interface fcoe port

Operands

port

VF_Port number

Defaults

None.

Command Modes

N_Port configuration mode

Description

Use this command to specify a route that AG will use to direct traffic from a device (host or target)
on a VF_Port to a fabric switch port connected to an Access Gateway N_Port. The process of
specifying routes is called “mapping.” Default mapping is enabled for the switch when enabling AG
for the first time, You can use the map command to change the default mapping.

Usage Guidelines

You must be in the configuration mode for the specific N_Port where you want to map a VF_Port
(refer to “nport”). N_Ports are designated by the format rbridge-id/port group/N_Port, such as
3/0/4 for RBridge 3. Use this format to correctly identify the N_Port in N_Port configuration mode.
VF_Ports are identified by the format domain/rbridge-id/VF_Port, such as 1/2/26.

Examples

Map VF_Port 1/2/26 to N_Port 2/0/4.

sw0(config-rbridge-id-2-ag-nport-if-fi-

2/0/4)# map fport interface fcoe 1/2/26

Remove map from VF_Port 1/2/26 to N_Port 2/0/4.

w0(config-rbridge-id-2-ag-nport-if-fi-

2/0/4)# no map fport interface fcoe 1/2/26