Apple Final Cut Pro 7 - Manual (Page 733)

To open the Trim Edit window
Do one of the following:
µ
Choose Sequence > Trim Edit (or press Command-7).
The playhead jumps to the closest edit point on the lowest-numbered track with Auto
Select turned on. The Trim Edit window shows the clips surrounding this edit point. By
default, both sides of the edit point are selected, so the Trim Edit window is set up to
perform a roll edit.
µ
Double-click an edit point in the Timeline with the Selection, Ripple, or Roll tool.
Double-click an edit point to
open the Trim Edit window.
The Trim Edit window displays the clips surrounding the edit point. The selected tool and
the part of the edit point you clicked determine the initial state of the green bars, which
define the kind of edit you can perform. Press the U key to switch between the Ripple
Outgoing, Roll, and Ripple Incoming trimming modes.
µ
Click an edit point or drag around one or more edit points using the Edit Selection tool.
You can also drag around
an edit point with the Edit
Selection tool to open the
Trim Edit window.
The Trim Edit window displays the clip items adjacent to the edit points you selected. If
you selected multiple edit points, the clip items located on the topmost video track are
displayed. You can change this using the Track pop-up menu.
To close the Trim Edit window
Do one of the following:
µ
Choose File > Close Window (or press Command-W).
733 Chapter 46 Trimming Clips Using the Trim Edit Window