Apple Final Cut Pro 7 - Manual (Page 1693)

If you’re in Editing mode: Use the transport controls in the Edit to Tape window to cue
the tape and set an In point, an Out point, or both, depending on the type of three-point
edit you’re doing.
• To set an In point: Cue the tape where you want to start your initial edit, or type a
value. Then press I or click the Mark In button.
• To set an Out point: Cue the tape where you want your clip or sequence to end, or
type a value. Then press O or click the Mark Out button.
Timecode for the
In point on the tape
Mark Out button Mark In button
Timecode for the
Out point on the tape
6 Select the destination video and audio tracks to be edited to in the Edit to Tape window.
When performing an insert edit, you can selectively record-enable the video, audio, and
timecode tracks on tape. Destination tracks that are disabled in the Edit to Tape window
are not overwritten on the destination tape.
Click here to enable
or disable timecode.
Choose your audio tracks
from this pop-up menu.
Click here to enable
or disable video.
7 If you are including leader elements using Mastering mode, click the Mastering Settings
tab, then select the elements you want to include before and after your sequence or clip.
For an explanation of the leader and trailer options, see “Adding Standard Leader and
Trailer Elements.”
1693 Chapter 101 Assemble and Insert Editing Using Edit to Tape