Apple Final Cut Pro 7 - Manual (Page 1981)

shuttle To drag the slider on the shuttle control to the right to fast-forward and to the
left to rewind. Playback speed varies depending on the distance of the slider from the
center of the control.
shuttle control The slider control located at the bottom of the Viewer and the Canvas.
This control is useful for continuous playback at different speeds, in fast and slow motion.
It also shifts the pitch of audio as it plays at varying speeds.
signal-to-noise ratio The ratio between the average loudness of the subject and the
background noise in a recording. Background noise can be many things—tape hiss, the
rustle of clothes, or the rumble of traffic. It’s important that the signal-to-noise ratio of
your recorded clips be fairly high, so that actors’ voices are comprehensible and clear.
slate A small board shot at the beginning of a scene, which identifies the scene with
basic production information such as the take, date, and scene number. The slate may
also contain a chip chart to aid in color correcting the scene. A clapper provides an
audiovisual cue for synchronization of dual system recordings.
slide edit An edit in which an entire clip is moved, along with the edit points on its left
and right. The duration of the clip being moved stays the same, but the clips to the left
and to the right of it change in length to accommodate the new position of the clip. The
overall duration of the sequence and of these three clips remains the same.
slider In Final Cut Pro, an interface element that can be dragged forward or backward in
order to make an adjustment. Sliders can be found in the Motion tab of the Viewer as
well as in filters and generators applied to a clip.
slip edit An edit in which the location of both In and Out points of a sequence clip are
changed at the same time, without changing the location or duration of the clip. This is
referred to as slipping because you slip a pair of In and Out points inside the available
footage.
slug A generator in Final Cut Pro used to create black video in a sequence. A slug can be
used to represent a video clip that has not yet been placed.
SMPTE (Society of Motion Picture and Television Engineers) The organization responsible
for establishing various broadcast video standards and the SMPTE standard timecode for
video playback.
snapping A setting in the Timeline that affects the movement of the playhead. When
snapping is turned on, the playhead “snaps,” or moves directly, to markers or edit points
when it is moved close to them.
Snapping button A button in the upper-right corner of the Timeline that you click to
turn snapping on and off.
1981 Glossary