Apple Final Cut Pro 7 User Manual
Page 1690
4
If you haven’t already done so, set In and Out points for your clip or sequence in the
Viewer, if you don’t want to output the entire clip or sequence.
If you wish, set In and
Out points for the part
you want to record.
5
In the Edit to Tape window, cue the tape where you want to start your initial edit, then
press I, click the Mark In button, or type a value and press Return.
Note: You do not need to set an Out point for an assemble edit.
6
If you are including leader elements using Mastering mode, click the Mastering Settings
tab, then select the elements you want to include before and after your sequence or clip.
For an explanation of the leader and trailer options, see
7
To perform the assemble edit, do one of the following:
• Drag your clip or sequence from the Viewer or Browser to the Assemble section of the
Edit Overlay.
• Open your clip or sequence in the Viewer, then click the Assemble Edit button.
• Drag the clip or sequence to the Assemble Edit button.
Drag the clip or
sequence here to do
an assemble edit.
Or click the Assemble
Edit button.
1690
Chapter 101
Assemble and Insert Editing Using Edit to Tape