Lenze 8400 TopLine - Manual (Page 998)

17 Parameter reference
17.2 Parameter list | C00493
998
Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00493
C00494
C00495
Parameter | Name:
C00493 | Hiperface: TypCode
Data type: UNSIGNED_8
Index: 24082
d
= 5E12
h
From version 02.00.00
 Encoder/feedback system: sin/cos absolute value encoder with HIPERFACE® protocol
Setting range (min. value | unit | max. value) Lenze setting
0 255 0
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00494 | Hiperface: Resolutions
Data type: UNSIGNED_32
Index: 24081
d
= 5E11
h
From version 02.00.00
 Encoder/feedback system: sin/cos absolute value encoder with HIPERFACE® protocol
Setting range (min. value | unit | max. value)
0 65536
Subcodes Lenze setting Info
C00494/1 0 Hiperface: Number of revolutions
C00494/2 0 Hiperface: Steps per revolution
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00495 | Speed sensor selection
Data type: UNSIGNED_8
Index: 24080
d
= 5E10
h
Selection of the feedback system for the actual speed for motor control and display
 Encoder/feedback system
Selection list (Lenze setting printed in bold) Info
0 No sensor No sensor available for the actual speed detection
1 Sensor signal FreqIn12 Speed sensor signal is fed via the digital DI1 and DI2
inputs
2 Encoder signal FreqIn67 Speed encoder signal is fed via digital inputs DI6 and DI7
3 Multi encoder Speed encoder signal is supplied via multi-encoder
interface
4 Resolver Speed encoder signal is supplied via resolver interface
5 Encoder signal FreqIn1267 From version 15.00.00
Speed encoder signal is fed via digital inputs DI1/DI2 and
DI6/DI7 (connection of 4-track HTL encoders)
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1