Lenze 8400 TopLine - Manual (Page 316)

6 Encoder/feedback system
6.1 Encoder selection
316
Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Parameterisation dialog in the »Engineer«
From the »Engineer« V2.19 , the following parameterisation dialog is available for parameterising
the encoder/feedback system. For a better overview, the parameterisation dialog contains different
categories which can be expanded/collapsed by a simple click. First, only the "encoder selection"
category is expanded:

Go to the Speed sensor selection list field and select the connected speed sensor.
After the selection, the respective category wit the parameters relevant for the selected
encoder is automatically expanded.
Parameter Info Lenze setting
C00495 Speed sensor selection
• Source of feedback signal for speed control.
0: No sensor
C00490 Position encoder selection
• Source of feedback signal for position control.
0: no sensor: nSpeedSetValue_a

Detailed information on the parameters of the other categories can be found in the
corresponding chapter:
 Resolver (X7) ( 319)
 Multi-Encoder (X8) ( 325)
 Frequency HTL encoder (DI1/DI2, DI6/DI7) ( 352)
 Pole position identification (PPI) ( 358)
 Mounting ( 367)
 Monitoring ( 368)
 Motor temperature monitoring (KTY) ( 373)