Lenze 8400 TopLine - Manual (Page 1181)

Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
1181
17 Parameter reference
17.2 Parameter list | C01220
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C01220
Parameter | Name:
C01220 | MCK: Ref. setting
Data type: UNSIGNED_16
Index: 23355
d
= 5B3B
h
From version 14.00.00
Settings for "homing" mode
 Homing
Setting range (min. hex value | max. hex value)
0x0000 0xFFFF
Value is bit-coded: Info
Bit 0 Reserved
Bit 1 Reserved
Bit 2 Reserved
Bit 3 Reserved
Bit 4 Start deletes bHomePosAvailable 1 ≡ When homing is started (mode 4 ... 15), the reference
information is deleted.
Bit 5 Maximum jerk 1 ≡ The maximum jerk is calculated based on the
acceleration and S-ramp time of the current profile and
the sequence profile. This is then used in an accelerated
drive for reducing the acceleration to 0 or for
acceleration of the sequence profile.

Setting or activation of maximum jerk for traversing
profiles
Bit 6 Reserved
Bit 7 Reserved
Bit 8 Reserved
Bit 9 Reserved
Bit 10 Reserved
Bit 11 Reserved
Bit 12 Reserved
Bit 13 Reserved
Bit 14 Reserved
Bit 15 Reserved
Subcodes Lenze setting Info
C01220/1 0x0000 MCK: Ref. setting
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT