4 enable/inhibit controller, Enable/inhibit controller, 4device control (dctrl) – Lenze 8400 TopLine User Manual
Page 107
![background image](/manuals/566308/107/background.png)
Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
107
4
Device control (DCTRL)
4.1
Device commands (C00002/x)
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4.1.4
Enable/Inhibit controller
The
= "1: On / start" device command enables the controller, provided that no other
source of a controller inhibit is active.
The
= "0: Off / ready" device command inhibits the controller again, i.e. the power
output stages in the controller are inhibited and the speed/current controllers of the motor control
are reset.
• The motor becomes torqueless and coasts, if it has not yet been in standstill.
• When the controller is inhibited, the status output bCInhActive of the
system
block is set to TRUE.
• When the controller inhibit request is reset, the drive synchronises to the actual speed. For this
purpose,
• If the flying restart circuit is activated in
, the flying restart function parameterised in
is used for the synchronisation to the rotary or standing drive.
• In the case of an operation with feedback, the actual speed is read out by the encoder system.
• In the case of a sensorless vector control (SLVC), the actual speed from the motor model of
the motor control is used for the synchronisation.
•
provides a bit coded representation of all active sources/triggers of a controller inhibit:
Tip!
The controller can also be enabled or inhibited via the
and
toolbar icons.
Bit Cause/Source of controller inhibit
Bit 0 Terminal controller enable
Bit 1 CAN control word
Bit 2 MCI control word
Bit 3 SwitchOn
Bit 4 Application (
system block: bCInh input)
Bit 5 Device command (
)
Bit 6 Error with a "Fault"/"Trouble" error response or system error, respectively
Bit 7 Internal signal
Bit 8
Reserved
Bit 9
Reserved
Bit 10 AutoStartLock
Bit 11 Motor parameter identification
Bit 12 Automatic brake operation
Bit 13 DCB-IMP
Bit 14
Reserved
Bit 15
Reserved