Lenze 8400 TopLine - Manual (Page 51)

Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
51
2 Introduction: Parameterising the controller
2.5 Device identification
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
2.5 Device identification
For device identification, any device name (e.g. wheel drive) with max 32 characters can be set in
C00199/1 for the controller and saved in the memory module with mains failure protection.
2.5.1 Automatic acceptance of the device name in the »Engineer«
If a device name is stored in C00199/1 and the controller is added to the project in the »Engineer«
via the Einfügen  Insert device detected online... function, the device name stored in
("8400 TopLine") C00199/1 (here: wheel drive) is used as device name instead of the type:
This mechanism also functions in reverse direction:
If you rename the controller in the project view via , you will be asked afterwards if you want to
take over the changed name in C00199/1 :
2.5.2 Extended item designation
This function extension is available from version 12.00.00!
In C00199/2...5 , four texts à max. 32 characters can be set for item designation and saved in the
memory module safe against mains failure. These additional subcodes are not dependent on the
previously described text acceptance mechanism in the »Engineer« for the device name ( C00199/1 ).