Lenze 8400 TopLine - Manual (Page 1042)

17 Parameter reference
17.2 Parameter list | C00654
1042
Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00654
C00658
C00659
C00660
Parameter | Name:
C00654 | Source of diff. setpoint feedforward control
Data type: UNSIGNED_8
Index: 23921
d
= 5D71
h
From version 12.00.00
Selection of the process signal for the setpoint feedforward control
Selection list
Info
0 nSpeedSetValue_a
1 nSpeedSetValueInertia_a
The new process signal nSpeedSetValueInertia_a at
SB LS_MotorInterface can be used to define any input
value (e.g. position or process controller setpoint) for
torque feedforward control.
Subcodes Lenze setting Info
C00654/1 0: nSpeedSetValue_a Source of diff. setpoint feedforward control
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00658 | PRBS amplitude
Data type: INTEGER_16
Index: 23917
d
= 5D6D
h
This code is for device-internal use only and must not be written to by the user!
Parameter | Name:
C00659 | PRBS duration
Data type: UNSIGNED_16
Index: 23916
d
= 5D6C
h
This code is for device-internal use only and must not be written to by the user!
Parameter | Name:
C00660 | L_FixSet_a_1: Analog values
Data type: INTEGER_16
Index: 23915
d
= 5D6B
h
FB L_FixSet_a_1 : Setting of the fixed values
Setting range (min. value | unit | max. value)
-199.99 % 199.99
Subcodes Lenze setting Info
C00660/1 0.00 % Fixed value 0 ... 15
C00660/...
C00660/16
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100