Lenze 8400 TopLine - Manual (Page 754)

12 System bus "CAN on board"
12.2 Possible settings via DIP switch
754
Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
12.2.2 Setting the baud rate
The baud rate can be set via code C00351 or with the DIP switches a to c:
12.2.3 Setting the node address
The node address can be set via code C00350 or with the DIP switches 1 to 64.
• The labelling on the housing corresponds to the values of the individual DIP switches for
determining the node address.
• The valid address range depends on the number of SDO channels set in C00366 :
• 1 SDO (Lenze setting): 1 ... 127
• 2 SDO: 1 ... 63

Note!
• All DIP switches (a ... c, 1 ... 64) = OFF (Lenze setting):
• At switching on, the settings under code C00350 (node address) and C00351 (baud
rate) will become active.
• Preset baud rate: 500 kbps
DIP switch position Baud rate
c b A
ON OFF ON 20 kbps
OFF ON ON 50 kbps
OFF ON OFF 125 kbps
OFF OFF ON 250 kbps
OFF OFF OFF 500 kbps
ON OFF OFF 1000 kbps

Note!
• The addresses of the nodes must differ from each other.
• All DIP switches (a ... c, 1 ... 64) = OFF (Lenze setting):
• At switching on, the settings under code C00350 (node address) and C00351 (baud
rate) will become active.