Lenze 8400 TopLine - Manual (Page 498)

8 Technology applications
8.4 TA "Table positioning"
498
Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
nAccOverride_a
INT
Value for Acceleration override
• Percentage multiplier for the currently active acceleration.
• 16384 ≡ 100 % of the parameterised acceleration of the corresponding operating
mode.
• If the override value is 0 %, acceleration ceases.
bHomeStartStop
BOOL
Homing : Start/stop homing
TRUE Start homing
TRUEFALSE Stop homing
bHomeSetPosition
BOOL
Homing : Set home position
TRUE Set home position
bHomeResetPosition
BOOL
Homing : Reset home position
TRUE Reset the "Reference known" status
bHomeMark
BOOL
Homing : Input for reference switch (pre-switch off mark)
• This input responds to the FALSE status (fail-safe) and is to be connected to the
corresponding digital input to which the reference switch is connected.
bPosSetProfilePosition
BOOL
Position teaching : MCK setpoint position
TRUE Teach MCK setpoint position into the selected profile.
bPosSetActualPosition
BOOL
Position teaching : Current position
TRUE Teach current position into the selected profile.
bPosExecute
BOOL
Positioning : Start travelling
FALSETRUE Execute selected profile
bPosFinishTarget
BOOL
Positioning : Complete cancelled profile
FALSETRUE A positioning process previously cancelled, e.g. by bPosStop or due to
a device error, is resumed by travelling to the original target.
bPosDisableFollowProfile
BOOL
Positioning : Do not execute sequence profile (switch-off profile linkage)
TRUE Evaluation of the sequence profile number parameterised in
C01307/1...15 for the selected profile is suppressed.
bPosStop
BOOL
Positioning : Cancel travelling
TRUE Stop positioning
From version 02.00.00 , more travel requests will be inhibited
("PosExecute" will be blocked).
Identifier
Data type
Information/possible settings