Lenze 8400 TopLine - Manual (Page 866)

16 Parameter change-over
16.2 Configuring the definable parameter list by means of parameterisation
866
Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
16.2 Configuring the definable parameter list by means of parameterisation
The following application example shows the necessary procedure for configuring the list without
using the »Engineer« parameterisation dialog.
Task:
The LS_WriteParamList SB is to be used to write to parameters
C00012 , C00026/1 and C00027/1 .
Compiling the parameter list
In
C01085/1 ... n , specify the above-named parameters in the , format:
• C01085/1 = 12.000
• C01085/2 = 26.001
• C01085/3 = 27.001
• C01085/4 ... n = 0.000 (no parameter)
Entering values for the parameters (value set 1)
In
C01086/1 ... n , specify the values to be used to describe the selected parameters. The values are
entered according to the scaling format/scaling factor of the respective parameter.
• C01086/1 = for list entry 1 (in our example: for parameter C00012 )
• C01086/2 = for list entry 2 (in our example: for parameter C00026/1 )
• C01086/3 = for list entry 3 (in our example: for parameter C00027/1 )
These values are used in the writing process if the two bSelectWriteValue_1 and
bSelectWriteValue_2 inputs are not assigned or both set to FALSE.
Entering other values for the parameters (value sets 2 ... 4)
If required, up to three other sets can be set in the same way in
C01087/1 ... n to C01089/1 ... n
which can optionally be written to the parameters. The decision as to which value set is finally used
is dependent upon the assignment of the two bSelectWriteValue_1 and bSelectWriteValue_2
inputs:

Note!
Gaps in the parameter list (setting = 0.000) are permissible and are skipped in the
process.
Invalid parameter entries are not accepted when being entered.