Lenze 8400 TopLine - Manual (Page 889)

Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
889
17 Parameter reference
17.2 Parameter list | C00010
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00010
C00011
C00012
Parameter | Name:
C00010 | AIN1: Characteristic
Data type: INTEGER_16
Index: 24565
d
= 5FF5
h
 Analog terminals : Signal adaptation via characteristic
Setting range (min. value | unit | max. value)
0.00 % 199.99
Subcodes Lenze setting Info
C00010/1 0.00 % AIN1: (+y0) = min
C00010/2 0.00 % AIN1: (+x0) = Dead band
C00010/3 0.00 % AIN1: (-y0) = (-min)
C00010/4 0.00 % AIN1: (-x0) = (-Dead band)
C00010/5 100.00 % AIN1: (+ymax)
C00010/6 100.00 % AIN1: (+xmax)
C00010/7 100.00 % AIN1: (-ymax)
C00010/8 100.00 % AIN1: (-xmax)
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100
Parameter | Name:
C00011 | Appl.: Reference speed
Data type: UNSIGNED_16
Index: 24564
d
= 5FF4
h
Setting the reference speed
• In the controller, all speed-related signals are processed to one reference variable in percent.
• Set a reference speed here that corresponds to 100 %.
• The frequency that corresponds to the set reference speed is displayed in C00059 .
Note:
This is not a maximum limitation!
All values in percent in the controller may be in a range of 0 ... 199.99 %.
Setting range
(min. value | unit | max. value) Lenze setting
50 rpm 60000 1500 rpm
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00012 | Accel. time - main setpoint
Data type: UNSIGNED_32
Index: 24563
d
= 5FF3
h
The L_NSet_1 FB: Acceleration time of the ramp generator for the main speed setpoint
• Generally, this ramp generator is used for all speed-controlled technology applications.
Setting range (min. value | unit | max. value) Lenze setting
0.000 s 999.999 2.000 s
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1000