Lenze 8400 TopLine - Manual (Page 1284)

17 Parameter reference
17.2 Parameter list | C02862
1284
Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C02862
C02863
C02864
Parameter | Name:
C02862 | Resolver gain
Data type: UNSIGNED_16
Index: 21713
d
= 54D1
h
 Encoder/feedback system: Resolver
Setting range (min. value | unit | max. value)
0.00 % 199.99
Subcodes Lenze setting Info
C02862/1 100.00 % Resolver: sine gain
C02862/2 100.00 % Resolver: cos gain
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100
Parameter | Name:
C02863 | Resolver: Phase error
Data type: INTEGER_16
Index: 21712
d
= 54D0
h
 Encoder/feedback system: Resolver
Setting range
(min. value | unit | max. value)
Lenze setting
-199.99 % 199.99 0.00 %
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100
Parameter | Name:
C02864 | MCTRL: Optimisiations
Data type: UNSIGNED_16
Index: 21711
d
= 54CF
h
From version 14.00.00
Activation of special functions of the internal motor control
Setting range
(min. hex value | max. hex value)
0x0000 0xFFFF
Value is bit-coded: Info
Bit 0 Motor temp. 90° for operation
without KTY
1 ≡ Warm machine. In case the temperature tracking is
not active, a motor temperature of 90 °C is assumed.

Temperature compensation within the motor control
Bit 1 No switch-off of the brake chopper
after 4s
1 ≡ Limitation of the operating time of the brake chopper
(brake transistor) is deactivated.

Braking operation/brake energy management
Bit 2 Brake chopper off in case of trip 0 ≡ No response of the brake chopper in the "Fault"
device status.
1 ≡ In the "Fault" device status, the brake chopper is
permanently switched off without any delay.

Braking operation/brake energy management
Bit 3 Reserved (do not change!)
Bit 4 Motor ident: Switching frequency
8kHz
Switching frequency for motor parameter identification:
0 ≡ 4 kHz
1 ≡ 8 kHz

Preventing a decrease of the switching frequency
Bit 5 Field/field weakening control in
500us
Cycle time for field weakening control:
0 ≡ 1 ms
1 ≡ 500 μs

Optimising the behaviour of the asynchronous motor
in the field weakening range