Lenze 8400 TopLine - Manual (Page 684)

10 Diagnostics & error management
10.5 Logbook
684
Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
10.5.4 Reading out logbook entries
With an online connection, the existing logbook entries can easily be displayed in the »Engineer«.
Alternatively, the logbook entries can also be read out via the corresponding parameters (e.g. using
the keypad).

How to display logbook entries in the »Engineer«:
1. In the Project view, select the 8400 TopLine controller.
2. Click the icon or select the OnlineGo online command to build up an online
connection with the controller.
3. Select the Diagnostics tab from the Workspace.
4. Click Logbook.
Example: Representation of the logbook in the »Engineer« V2.13

Note!
Reading out the logbook entries is only permissible by one engineering tool at a time!
• If the logbook entries are tried to be read out via two engineering tools at the same
time, missing lines or a permanent refresh may be caused.
• The parameter interface for reading out the logbook by an external
control/visualisation, is available as well.  Reading out the logbook from an external
control/visualisation ( 687)