Lenze 8400 TopLine - Manual (Page 713)

Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
713
10 Diagnostics & error management
10.9 Error messages of the operating system
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Id7: Motor control does not match motor data [xx.0123.00060]
Id8: Speed encoder has not been set [xx.0123.00061]
Sd8: Encoder angular drift monit. [xx.0123.00062]
oC12: I2xt overload - brake resistor [xx.0123.00065]
oC11: Clamp operation active [xx.0123.00071]
Response (Lenze setting printed in bold) Setting: C00571/1 ( Adjustable response)
 0: No Reaction  1: Fault  2: Trouble  3: TroubleQuickStop  4: WarningLocked  5: Warning  6: Information
Cause Remedy
At controller enable, the device has detected that the
motor control type set in C00006 cannot control the
motor type set.
• Example: Motor nameplate data for an asynchronous
motor have been entered; however, a motor control
type for a synchronous motor is set in C00006 .
Note:
Since the "VFCplus" control types are able to control
every motor to a certain extent, this error message will
never occur here.
Enter correct motor nameplate data and set a matching
motor control type in C00006 :
• Motor nameplate data asynchronous motor  motor
control type must be ASM, SLVC or VFCplus servo
control.
• Motor nameplate data synchronous motor  motor
control type must be PSM, SLPSM or VFCplus servo
control.
Response (Lenze setting printed in bold) Setting: C00571/2 ( Adjustable response)
 0: No Reaction  1: Fault  2: Trouble  3: TroubleQuickStop  4: WarningLocked  5: Warning  6: Information
Cause Remedy
When being In controller enable status, the device has
detected that a motor control type with feedback has
beent set in C00006 , but no speed sensor has been set in
C00495 .
Set the speed sensor in C00495 .
Note: The error can only be reset if the settings in C00006
and C00495 match.
Response (Lenze setting printed in bold) Setting: C00603/3 ( Adjustable response)
 0: No Reaction  1: Fault  2: Trouble  3: TroubleQuickStop  4: WarningLocked  5: Warning  6: Information
Cause Remedy
• Encoder signal interferences (EMC).
• Encoder cable interrupted.
• Encoder defective.
• Faulty parameter setting of the encoder.
• Check encoder cable, use shorter encoder cable if
required.
• Check encoder.
• Check parameter setting.
• If required, switch off monitoring ( C00603/3 ).
Response (Lenze setting printed in bold)
 0: No Reaction  1: Fault  2: Trouble  3: TroubleQuickStop  4: WarningLocked  5: Warning  6: Information
Cause Remedy
Too frequent and too long braking processes. Check drive dimensioning.
Response (Lenze setting printed in bold)
 0: No Reaction  1: Fault  2: Trouble  3: TroubleQuickStop  4: WarningLocked  5: Warning  6: Information
Cause Remedy
The device indicates that the "CLAMP" overcurrent
limitation has been activated.
• A permanent clamp operation causes an overload
disconnection.
Reduce setpoint generation dynamics or motor load.