Lenze 8400 TopLine - Manual (Page 132)

4 Device control (DCTRL)
4.4 Internal interfaces | "LS_DriveInterface" system block
132
Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4.4.2 wDeviceStatusWord status word
The wDeviceStatusWord status word provided by the control system contains all information
relevant for controlling the controller.
• The status word is sent as a process data word to the master control via a port block:
• The LP_CanOut1 port block if "CAN on board" is used or
• the LP_MciOut1 port block if a plugged-in communication module is used (e.g. PROFIBUS).
• Display parameter: C00150
• The bit assignment of the wDeviceStatusWord status word can be seen from the table below.
Bit Name Status
Bit 0 FreeStatusBit0 Free status bit 0
Bit 1 PowerDisabled 1 ≡ Inverter control inhibited (pulse inhibit is active)
Bit 2 FreeStatusBit2 Free status bit 2 (not assigned, freely assignable)
Bit 3 FreeStatusBit3 Free status bit 3 (not assigned, freely assignable)
Bit 4 FreeStatusBit4 Free status bit 4 (not assigned, freely assignable)
Bit 5 FreeStatusBit5 Free status bit 5 (not assigned, freely assignable)
Bit 6 ActSpeedIsZero During open-loop operation:
1 ≡ Speed setpoint < Comparison value ( C00024 )
During closed-loop operation:
1 ≡ Actual speed value < Comparison value ( C00024 )
Bit 7 ControllerInhibit 1 ≡ Controller inhibited (controller inhibit is active)
Bit 8 StatusCodeBit0 Bit coded display of the active device status
 Device state machine and device states (see table [4-1] )
Bit 9 StatusCodeBit1
Bit 10 StatusCodeBit2
Bit 11 StatusCodeBit3
Bit 12 Warning
1 ≡ A warning is indicated
Bit 13 Trouble 1 ≡ Controller is in the " Trouble " device status
• E.g. if an overvoltage has occurred.
Bit 14 FreeStatusBit14 Free status bit 14 (not assigned, freely assignable)
Bit 15 FreeStatusBit15 Free status bit 15 (not assigned, freely assignable)