Lenze 8400 TopLine - Manual (Page 351)

Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
351
6 Encoder/feedback system
6.3 Multi-Encoder (X8)
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
6.3.5.1 Scaling of position value
If you click the Scaling of position value... button in the parameterisation dialog for the
encoder/feedback system in the category "Multi-Encoder (X8), you get to the respective
parameterisation dialog:
Short overview of the relevant parameters:
6.3.5.2 Setting of a static position offset
If, for example, the encoder cannot be mounted mechanically in order that the supplied position
matches the mechanics or if for other reasons, a static position offset is required, this value can be
set in C01112/1 .
Parameter Info Lenze setting
Value Unit
C01110 LS_MultiEncoder: Solid measure
• Setting of rotative or linear encoders.
Note: The selection "rotative" or "linear" only has an
impact if the encoder has not been detected
automatically or the encoder data definitely are to be
taken from the codes (bit 0 in C00499/1 is set to "1").
The "unipolar" or "bipolar" selection definitely has an
impact.
0: rotatively unipolar
Settings for linear SinCos absolute value encoder with HIPERFACE® protocol
C01111/1 LS_MultiEncoder: Difference - traverse path
• Specification of the traverse path while passing
through the step number of the Hiperface track
given in C01111/2 .
• Setting is relevant for parameter channel.
1 units
C01111/2 LS_MultiEncoder: Difference - encoder path
• Step number of the Hiperface track.
• Setting is relevant for parameter channel.
1 Steps
C01111/3 LS_MultiEncoder: Traverse path - encoder increment
• Specification of the traverse path while passing
through the number of increments of the SinCos
track given in C00420/3 .
• Setting is relevant for process data channel
(incremental SinCos track).
1 units
Further settings
C01204 MCK: Feed constant 360.0000 units/rev.