Lenze 8400 TopLine - Manual (Page 963)

Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
963
17 Parameter reference
17.2 Parameter list | C00368
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00368
C00369
Parameter | Name:
C00368 | CAN SYNC Tx identifier
Data type: UNSIGNED_16
Index: 24207
d
= 5E8F
h
Identifier by means of which the sync master is to transmit sync telegrams.
• Mapping of the CANopen object I-1005 (see DS301 V4.02).
 "CAN on board" system bus
Setting range (min. hex value | max. hex value) Lenze setting
0x0000 0xFFFF 0x0080 (decimal: 128)
Value is bit-coded: ( = bit set)
Bit 0  COBID Bit0
Bit 1  COBID Bit1
Bit 2  COBID Bit2
Bit 3  COBID Bit3
Bit 4  COBID Bit4
Bit 5  COBID Bit5
Bit 6  COBID Bit6
Bit 7  COBID Bit7
Bit 8  COBID Bit8
Bit 9  COBID Bit9
Bit 10  COBID Bit10
Bit 11 
Reserved
Bit 12  Reserved
Bit 13  Reserved
Bit 14  Reserved
Bit 15  Sync-transmit off
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT
Parameter | Name:
C00369 | CAN sync transmission cycle time
Data type: UNSIGNED_16
Index: 24206
d
= 5E8E
h
Cycle during which the sync master is to transmit sync telegrams.
• If "0 ms" is set (Lenze setting), no sync telegrams are generated.
• Mapping of the CANopen object I-1006 (see DS301 V4.02).
 "CAN on board" system bus
Setting range (min. value | unit | max. value) Lenze setting
0 ms 65000 0 ms
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1