Lenze 8400 TopLine - Manual (Page 1268)

17 Parameter reference
17.2 Parameter list | C02444
1268
Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C02444
C02580
Parameter | Name:
C02444 | CAB configuration
Data type: UNSIGNED_16
Index: 22131
d
= 5673
h
From version 12.00.00
Bit-coded settings
 Data transfer axis bus
Setting range (min. hex value | max. hex value)
0x0000 0xFFFF
Value is bit-coded: Info
Bit 0 Edge detection SetFail 0 ≡ input bSetFail_DigOut is level-sensitive.
1 ≡ input bSetFail_DigOut is edge-sensitive.
Bit 1 Reserved
Bit 2 Reserved
Bit 3 Reserved
Bit 4 Reserved
Bit 5 Reserved
Bit 6 Reserved
Bit 7 Reserved
Bit 8 Reserved
Bit 9 Reserved
Bit 10 Reserved
Bit 11 Reserved
Bit 12 Reserved
Bit 13 Reserved
Bit 14 same CobId for all Cas
Bit 15 500 kbps
Subcodes Lenze setting Info
C02444/1 0x0000 Axis bus configuration
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT
Parameter | Name:
C02580 | Holding brake: Operating mode
Data type: UNSIGNED_8
Index: 21995
d
= 55EB
h
Selection of the operating mode for holding brake control
 Holding brake control
Selection list (Lenze setting printed in bold) Info
0 Brake control off No holding brake is used. Internal control is switched off.
11 Manually controlled The holding brake is released and closed via a control bit
in the MCK control word.
12 Autom. controlled The holding brake is automatically released and closed
via speed setpoint comparisons.
13 Semi-automat. controlled The holding brake is released and closed via a control bit
in the MCK control word.
• In contrast to the manual operation (mode 11)
• the feedforward control is active in this mode,
preventing a sagging e.g. in case of a hoist.
• the brake in this mode also closes when the
controller is inhibited in order to prevent the axis in
a hoist from falling.
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1