Lenze 8400 TopLine - Manual (Page 1334)

18 Working with the FB Editor
18.1 Basics
1334
Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
18.1.2 Conventions used for input/output identifiers
This chapter describes the conventions used for the identifiers of the inputs/outputs of the blocks.
The conventions ensure a uniform and consistent terminology and make reading and
comprehending the interconnection and application easier.

Tip!
The conventions used by Lenze are based on the "Hungarian Notation". This ensures that
the most significant characteristics of the corresponding input/output (e.g. the data type)
can be instantly recognised from its identifier.
An identifier consists of
• a data type entry
• an identifier (the "proper" name of the input/output)
• an (optional) signal type specification
Data type entry
The data type entry provides information about the data type of the corresponding input/output:
Identifier
The identifier is the proper name of the input/output and should indicate the application or
function.
• Identifiers always start with a capital letter.
• If an identifier consists of several "words", then each "word" must start with a capital letter.
• All other letters are written in lower case.
Data type entry Meaning Resolution Value range
b BOOL 1 bit 0 ≡ FALSE / 1 ≡ TRUE
dn DINT 32 bits -2147483647 ... 2147483647
n INT 16 bits -32767 ... 32767
w WORD 16 bits 0 ... 65535