Lenze 8400 TopLine - Manual (Page 147)

Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
147
5 Motor control (MCTRL)
5.1 Motor selection/Motor data
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Execute automatic motor parameter identification

How to carry out automatic motor parameter identification:
1. Activate motor parameter identification via the C00002/23 = "1: On / start" device
command.
2. Enable controller.
• The controller changes to the " Ident " device status.
• Motor parameter identification starts.
• The progress of the identification run can be seen in
C00002/23 .
• The identification is completed if the "0: Off / ready" message is displayed in C00002/23 .
• After successful identification, it changes back to the " SwitchedOn " device status.
3. Inhibit controller again.

Danger!
During motor parameter identification, the motor is energised via the outputs U, V and
W of the controller!
• Observe the corresponding safety instructions!
• With an idling motor, a small angular offset may occur at the motor shaft.
• During the motor parameter identification, rotations occur in case of a synchronous
motor.