Lenze 8400 TopLine - Manual (Page 514)

8 Technology applications
8.4 TA "Table positioning"
514
Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Output words Name Assignment
Word 1 DriveControlStatus Status word
• For bit assignment see the table below.
Word 2 GPSignalOut1 Analog signal monitor: Output signal 1
• The selection of the signal source to output is executed in
C00410/1 .
• Gain and offset for the output signal can be parameterised in
C00413/1 and C00413/2 .
• For a detailed functional description see
the L_SignalMonitor_a FB.
Word 3 and 4 SetPos Absolute position setpoint in [increments]
• 65535 [Increments] ≡ 1 motor revolution
• The position resolution, i.e. how many increments form one
unit, is displayed in C01205 .
Word 5 MotorSpeedAct Actual speed value
• Scaling: 16384 ≡ 100 % reference speed ( C00011 )
• Only available in control mode "40: MCI".
Word 6 ... 16 - Not preconfigured
• Only available in control mode "40: MCI".
Status word Name Status
Bit 0 DriveFail 1 ≡ Drive controller in error status
• " Fault " device status is active.
Bit 1 GPSignalOut1 Binary signal monitor: Output signals 1 & 2
• The signal sources to be output are selected in C00411/1...2 .
• A bit coded inversion of the output signals can be
parameterised in C00412 .
• For a detailed functional description see
FB L_SignalMonitor_b .
Bit 2 GPSignalOut2
Bit 3 CInhActive 1 ≡ Controller inhibit is active
Bit 4 DriveReady 1 ≡ Drive controller is ready for operation
• " SwitchedOn " device status is active.
• The drive is in this device status if the DC bus voltage is
applied and the controller is still inhibited by the user
(controller inhibit).
Bit 5 DigitalInput5 Signal from the digital input DI5
Bit 6 DigitalInput6 Signal from the digital input DI6
Bit 7 DigitalInput7 Signal from the digital input DI7
Bit 8 InTarget 1 ≡ Target position (actual value) is in the target window
Bit 9 ProfileBusy 1 ≡ Profile positioning is active
Bit 10 HomePosAvailable 1 ≡ Home position is known
Bit 11 SpeedActCompare Result of the speed comparison (detection of speed=0)
• In case of the "Open loop" operation:
1 ≡ Speed setpoint < comparison value ( C00024 )
• For "Closed loop" operation:
1 ≡ actual speed value < comparison value ( C00024 )
Bit 12 DigitalInput4 Signal from the digital input DI4
Bit 13 DigitalInput3 Signal from the digital input DI3
Bit 14 QSPIsActive 1 ≡ Quick stop is active
Bit 15 - Free status bit 15 (not assigned, freely assignable)