Lenze 8400 TopLine - Manual (Page 860)

16 Parameter change-over
16.1 Configuring parameter change-over via the »Engineer« parameterisation dialog
860
Lenze · 8400 TopLine · Reference manual · DMS 6.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
16.1 Configuring parameter change-over via the »Engineer« parameterisation dialog

Proceed as follows to open the dialog for parameterising the parameter change-over:
1. »Engineer« Go to the Project view and select the 8400 TopLine controller.
2. Select the Application parameters tab from the Workspace.
3. Go to the Overview dialog level and click the "Basic functions" button.
4. Go to the Overview  Basic functions dialog box and click the Parameter change-over
button.

Note!
The "parameter change-over" basic function is always processed, even if the
corresponding LS_WriteParamList system block has been removed from the
interconnection by the function block editor.
If you do not require this basic function anymore, delete the composed parameter list in
order that no unwanted parameter write operations take place.